Subject:
|
Re: Worm gear driven turntable
|
Newsgroups:
|
lugnet.build.mecha
|
Date:
|
Wed, 11 Jan 2006 16:21:52 GMT
|
Viewed:
|
1991 times
|
| |
|
|
In lugnet.build.mecha, Mitchell Lichtenberg wrote:
> In lugnet.build.mecha, Christopher Snead wrote:
> > So I've been working on various wormgear combinations over the past week or so,
> > and I came up with something that might be of use to folks:
> >
> > http://brickshelf.com/cgi-bin/gallery.cgi?i=1567084
>
> Great Job! But I had trouble with the top. There appear to be four 4 x 4
> plates that fit over the small turntable and are wedged against the axle so as
> to form a surface that spins with the axle. When I try this, the plates do not
> fit. Are those special plates or have I missed something here. Thanks
I think it's actually a 2x2 round plate in the center, with four 2x2 corner
plates surrounding it. It's a bit hard to tell from the photo though.
-Elroy
|
|
Message has 1 Reply:
Message is in Reply To:
 | | Re: Worm gear driven turntable
|
| (...) Great Job! But I had trouble with the top. There appear to be four 4 x 4 plates that fit over the small turntable and are wedged against the axle so as to form a surface that spins with the axle. When I try this, the plates do not fit. Are (...) (19 years ago, 11-Jan-06, to lugnet.build.mecha)
|
10 Messages in This Thread:
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
