 | | Re: LCadville
|
|
(...) How about going the extra step and making the 8-stud plates? -- Jonathan Wilson wilsonj@xoommail.com (URL) (27 years ago, 5-Sep-99, to lugnet.cad)
|
| |
| | Re: fire torso & hat (was: Re: LCadville)
|
|
(...) Nope. I was pointing out that it was being done -- Jonathan Wilson wilsonj@xoommail.com (URL) (27 years ago, 5-Sep-99, to lugnet.cad)
|
| |
| | Re: Datsville
|
|
(...) We should hold back on trains untill someone makes the curved track pieces. And yes trains can do hills. -- Jonathan Wilson wilsonj@xoommail.com (URL) (27 years ago, 5-Sep-99, to lugnet.cad)
|
| |
| | Re: Large wooden door
|
|
(...) It in in the current vote! -- Jonathan Wilson wilsonj@xoommail.com (URL) (27 years ago, 5-Sep-99, to lugnet.cad.dev)
|
| |
| | Re: decoding a message sent by an RCX
|
|
(...) I wondered about that - hardly any traffic in the newsgroup despite numerous downloads of NQC. I hope its because people are just too busy building stuff and programming it with NQC and RcxCC. Perhaps I should add a few more bugs to NQC just (...) (27 years ago, 5-Sep-99, to lugnet.robotics.rcx.nqc)
|
| |
| | Re: Datsville
|
|
(...) Post them in the lugnet.cad.dat.models newsgroup, with Datsville in the subject line. Can't wait to see it. -John Van (27 years ago, 5-Sep-99, to lugnet.general)
|
| |
| | Re: datsville monument
|
|
(...) Nor would there be anything but this. (...) I assume the torso is your own artwork? Could you post another copy with the torso inlined? Also, perhaps another 4x4 round for height? Otherwise, wonderfull! Now I'll have to insert spotlights for a (...) (27 years ago, 5-Sep-99, to lugnet.cad)
|
| |
| | (canceled)
|
|
|
| |
| | Re: Datsville
|
|
Heya all ! Where may I send my .DAT models when I want them give in Datsville ? Rene (27 years ago, 5-Sep-99, to lugnet.general)
|
| |
| | Re: RCX Currnet Rating?
|
|
(...) I'd bet you are safe with a 200 mA adapter. I have been using a 120 mA adapter for a while now with no problems. -Kekoa (27 years ago, 5-Sep-99, to lugnet.robotics.rcx)
|
