| | Re: Base plate thickness?
|
|
(...) Thanks, Scott. That's very helpful. I've got to get me some calipers! Rafe (17 years ago, 5-Feb-08, to lugnet.general)
|
|
| | Re: Which CAD program recommended for Mac??
|
|
(...) Moving things manually a long distance is cumbersome, even with the coarse grid. The inspector does show the coordinates of the selected part or submodel, although I'm not sure if that's what you mean by cursor coordinates. Note that if you do (...) (17 years ago, 5-Feb-08, to lugnet.cad, lugnet.cad.dev.mac)
|
|
| | Re: Base plate thickness?
|
|
(...) 0.055 inch would be correct. It never crossed my mind that 0.5 = 1/2. I don't use my calipers often enough to correctly interpret its output every time I do. Lesson learned: Double, uh, no, triple-check the readout (and make shure I'm (...) (17 years ago, 5-Feb-08, to lugnet.general)
|
|
| | Re: Which CAD program recommended for Mac??
|
|
(...) Yes, this is very annoying as using the arrow keys to move a part/assembly all the way across the model can be slow and painful, especially since Bricksmith doesn't seem to display cursor coordinates. (...) Ok, I see. I'd like functionality to (...) (17 years ago, 4-Feb-08, to lugnet.cad, lugnet.cad.dev.mac)
|
|
| | Re: Base plate thickness?
|
|
(...) Scott, I'm sorry; That can't be right. More than half an inch? Did you mean 0.055 inch? I'm talking about the thickness of a baseplate, the area without the studs, the distance a block would be above my desk if the block were sitting on a (...) (17 years ago, 4-Feb-08, to lugnet.general)
|