 | | Re: 8275 Bulldozer alternate fix
|
|
(...) I had something else I forgot to mention earlier: one of my 2L notched pins still had a considerable amount of flash that had to be cut off. The tolerances seem slightly off too, some of the longer studless beams take a lot of force to get the (...) (17 years ago, 29-Oct-07, to lugnet.technic, FTX)
|
| |
| | Re: Non-fluo trans orange?
|
|
(...) You're right. My mistake. -Orion (17 years ago, 29-Oct-07, to lugnet.cad.dat.parts)
|
| |
| | Re: S@H PAB shipping times
|
|
(...) I emailed them about this order and they replied that there was a technical glitch with it during processing. They apologized and said it should be fulfilled tomorrow or the next day and sent out right after that. Good thing I did ask - here I (...) (17 years ago, 29-Oct-07, to lugnet.market.shipping, FTX)
|
| |
| | Re: Non-fluo trans orange?
|
|
(...) I don't know what LEGO color T182 is, but based on Philippe's title, I'm guessing it's the (relatively) new trans orange (non-fluorescent). Assuming this is the case, then color 57 isn't it. --Travis (17 years ago, 29-Oct-07, to lugnet.cad.dat.parts)
|
| |
| | Re: Non-fluo trans orange?
|
|
(...) Per the ldconfig.ldr ((URL) file, color 57 is correct. -Orion (17 years ago, 29-Oct-07, to lugnet.cad.dat.parts)
|
| |
| | Re: Part 2609b
|
|
Dean Earley schrieb: (...) Hi, the current 2609 should be renamed to 2609a. cu mikeheide (17 years ago, 29-Oct-07, to lugnet.cad.dat.parts)
|
| |
| | Re: Part 2609b
|
|
Dean Earley schrieb: (...) Hi, maybe this (URL) helps. I only have one part and that has also a groove. On the pictures also only parts with groove are shown. So maybe it has always grooves. cu mikeheide (17 years ago, 29-Oct-07, to lugnet.cad.dat.parts)
|
| |
| | Re: Part 2609b
|
|
(...) As I'm rewriting 2609 to make use of a load more primitives, is there a version of either of these without the groove? The current LDraw part doesn't but all my real pieces do. (17 years ago, 29-Oct-07, to lugnet.cad.dat.parts)
|
| |
| | Part 2609b
|
|
Hi all. I have a magnet holder labelled 2609 but is about 4 LDU taller than the current part. Shall I just submit it as 2609b and what needs to be done with the current 2609? Thanks (17 years ago, 29-Oct-07, to lugnet.cad.dat.parts)
|
| |
| | Kit ordering closes soon at Lions Gate Models
|
|
Ordering for the second batch of kits will close at midnight Pacific time on October 31st. Yes, better get your order in while the kiddies beat down your door looking for candy :-). Those available include current kits like the Car Ferry and (...) (17 years ago, 29-Oct-07, to lugnet.market.buy-sell-trade)
|
