|
|
 | | RE: ideas for a RIS 2.0
|
| (...) But it IS true, and that's why the 6 input mux at: (URL) has some problems. Find out for yourself by putting a meter across a touch sensor. The resistance changes from about 1K to 470R when pressed depending on how hard it is pressed. Michael (...) (25 years ago, 24-Aug-99, to lugnet.robotics)
| | | | | Re: Train doors and windows
|
| (...) I'm interested too, but is it possible to get a short discription of the parts noted here above. I can only track the numbers 4182,4033 back !! Most of my doors have *NO* number on it, and when they does,its marked on the RIGHT HAND door,not (...) (25 years ago, 24-Aug-99, to lugnet.trains)
| | | | | Re: ideas for a RIS 2.0
|
| (...) gradually depress the sensor. There is not a sharp cutoff like there is with a typical contact switch. I tried building a touch sensor multiplexor, but I was unable to reliably get even 3 to work because the minimum resistance is quite large (...) (25 years ago, 24-Aug-99, to lugnet.robotics)
| | | | | Obj.: r/c servos
|
| To add more to all those servo information, I've build a servo controller which use the printer connector on the PC. It doesn't use any electronic, everything is made by software (Delphi 3.0) It is quite usefull to try this at home since you'll (...) (25 years ago, 23-Aug-99, to lugnet.robotics)
| | | | | Re: ideas for a RIS 2.0
|
| (...) If that were true, then the following multi-touch-sensor adapters would not work: (2 URLs) Robert Munafo (URL) LEGO: TC+++(8480) SW++ #+ S-- LS++ Hsp M+ A@ LM++ YB64m IC13 (25 years ago, 24-Aug-99, to lugnet.robotics)
|
|
