 | | Imperial Star Destroyer 10030
|
|
Are all the 10030 ((URL) on the market made in old gray ? (20 years ago, 11-May-06, to lugnet.color)
|
| |
| | Re: A Beautiful Machine prototype and perhaps a challenge/idea
|
|
(...) Very nifty! Another way would be to have a second switch that is on except when the scissors are at the bottom, and wire it in parallel with the activation switch. Sorta like how they get car windscreen wipers to always go back to the right (...) (20 years ago, 11-May-06, to lugnet.robotics)
|
| |
| | Re: High speed train instructions: not quite an MOC
|
|
(...) Very odd. It works fine for me. I just tested a couple of minutes ago. Tim (20 years ago, 11-May-06, to lugnet.trains, FTX)
|
| |
| | Re: NXT to NXT communication?
|
|
(...) Sounds like it's a firmware block though, so hopefully it can be overcome with "NxtOS" or whatever in future. ROSCO (20 years ago, 11-May-06, to lugnet.robotics)
|
| |
| | Re: High speed train instructions: not quite an MOC
|
|
(...) Seems the secrecy is very effective, as I get page not found. ROSCO (20 years ago, 11-May-06, to lugnet.trains, FTX)
|
| |
| | Re: Review of 7897 Passenger Train available at ILTCO site
|
|
(...) I think Ondrew was talking about the "time-out" mentioned somewhere, that the IR electronics switches off after a certain time if there's no signal from the controller. I'd be interested in knowing that too. Also, if you get a chance, could (...) (20 years ago, 11-May-06, to lugnet.trains)
|
| |
| | Re: A Beautiful Machine prototype and perhaps a challenge/idea
|
|
(...) <snip> (...) <snip> It is slightly more complicated than that. In order to make it go up slow enough to be interesting, I had to gear down the speed of the motor. As such I go from 8 teeth (I think) on the motor to the big 40 (?) teeth on the (...) (20 years ago, 11-May-06, to lugnet.robotics)
|
| |
| | Re: LEGO Factory price list - Tiles
|
|
Thanks for work and posting this.It should be noted that for the first time grey 2x2 tiles(bley however)are aval. in some what bulk form.Chris (...) (20 years ago, 11-May-06, to lugnet.market.shopping, FTX)
|
| |
| | Re: The perfect power strip...
|
|
(...) While on the subject of power suppies. It's been mentioned in the past by others, but I recomend swapping in a slightly beefier transformer to run your trains. The LEGO train power controller can output upto 1 amp, but most of the wallwarts (...) (20 years ago, 11-May-06, to lugnet.trains.org, FTX)
|
| |
| | Re: A Beautiful Machine prototype and perhaps a challenge/idea
|
|
(...) Very interesting, if a rather disturbing implementation. I had heard of the conecpt, but not seen those vids. The prosthetic is just a big creepy. (...) I like your version, first its more cute and friendly, and secondly you can see the (...) (20 years ago, 11-May-06, to lugnet.robotics)
|
