| | trouble with memory
|
|
Dear Fred Martin, I'm in deep deeeep trouble! A few weeks ago I first read about your handyboard and was very excited about it, because I was looking for a controller board for my autonomous vacuum cleaner. So I ordered the PCB from Douglas (...) (27 years ago, 11-Dec-97, to lugnet.robotics.handyboard)
|
|
| | email change
|
|
I know this probably isnt the right place to do this, but could you please change my email address from mdowney@eng.ua.edu to mdowney@dbtech.net Thanks....Sorry for the intrusion. Carry on! :) (27 years ago, 9-Dec-97, to lugnet.robotics.handyboard)
|
|
| | (no subject)
|
|
EAS is now taking orders for the Finger Board, a very small 68hc11 micro controller board with memory and I/O selects compatible to "Handy Board". You can easily design custom interface circuitry for it by using standard prototype boards. It runs (...) (27 years ago, 9-Dec-97, to lugnet.robotics.handyboard)
|
|
| | Spectra sonar pin outs
|
|
Here is the pin outs that you requested Randy. The board that you are talking about has a 17 pin SIP connector. What I did is remove this connector and solder a ribbon wire to the following pins: Signal Pin # (pin 17 and pin 1 should be labeled) GND (...) (27 years ago, 9-Dec-97, to lugnet.robotics.handyboard)
|
|
| | Re: Interrupt Programming
|
|
(...) (27 years ago, 9-Dec-97, to lugnet.robotics.handyboard)
|