 | | Re: IR devices
|
|
Hi Jeremy! I used the shaft encoder out of a track ball for my robotic project(same thing but a bit bigger). You do not need the IC out of the mouse just take the shaft encoder and use it with a IR led and detector pair. If you are going to use the (...) (27 years ago, 10-Nov-97, to lugnet.robotics.handyboard)
|
| |
| | Re: Burning hot motor driver chips.
|
|
Hello, RC car motors pull a lot of current, from 2A to 8A. The L293D chip goes up to 1A peak (for some miliseconds) before it shuts down. I suggest bypassing the L293D chips and using something like the LMD18200. (URL) Good luck, Marco A.A. de (...) (27 years ago, 10-Nov-97, to lugnet.robotics.handyboard)
|
| |
| | Project Questions
|
|
Three of us are undertaking a project using the Handyboard as the control system for a class at MIT. Our project, an autonomous blimp, has an unusual set of constraints, but we're hoping that your collective experience might be able to help us (...) (27 years ago, 9-Nov-97, to lugnet.robotics.handyboard)
|
| |
| | Re: Burning hot motor driver chips.
|
|
(...) sounds reasonable.. which "car" BTW? Some may be using that very same platform and may have some timely advice for you. (...) sounds like overload/overheating cutoff to me. (...) This is from the Handy Board FAQ : <---snip---> It is possible (...) (27 years ago, 9-Nov-97, to lugnet.robotics.handyboard)
|
| |
| | Re: Burning hot motor driver chips.
|
|
Anthony, (...) Yes it sounds like it. (...) It does. The L293D still works after it cools off, doesn't it? (...) I suspect you are going to need more than just two piggy backed L293D. (...) You might have a look at Ben Wirz website, he sells various (...) (27 years ago, 9-Nov-97, to lugnet.robotics.handyboard)
|
