 | | Re: Serial Device Interfacing
|
|
B> It will be used to control a LM197x digital Attenuator which has a B> 3 wire serial interface. B> Is it possible to wiggle the output lines in such a way ? Any B> hints ? If it is a 3 wire interface, does this imply synchronous? That sounds like (...) (27 years ago, 27-Oct-97, to lugnet.robotics.handyboard)
|
| |
| | Error in bootstrap mode
|
|
Dear Sir I start a Handy Board assembly and till now my board has passed the following steps : Microprocessor Power Circuitry ---- Passed Voltage Monitor Chip ---- Passed Microprocessor and Oscillator Circuit ---- Passed The problem focused at the (...) (27 years ago, 27-Oct-97, to lugnet.robotics.handyboard)
|
| |
| | Serial Device Interfacing
|
|
OK Newbie Allert !!! I'm looking at the Handy Board as a major step up from the Basic Stamp 2, but I need to be able to send out serial messages from the digital outputs. On the BS2 it is declared as a ShiftOut instruction. It will be used to (...) (27 years ago, 27-Oct-97, to lugnet.robotics.handyboard)
|
| |
| | New E-Mail Address Notification
|
|
Update your records! Customer BERND KLEIN has recently obtained a new e-mail address from NET@DDRESS a service of USA.NET. You can now reach this person via e-mail at bernd.klein@usa.net. This change is effective immediately. If you would like to (...) (27 years ago, 27-Oct-97, to lugnet.robotics.handyboard)
|
| |
| | HB site and 2.x web browsers
|
|
So all of my work is incompatible with version 2.x browswers, which don't colorize text. As an interim solution, I have created a site index page -- a single page that points to all pages linked from what are invisible menus if you have a 2.x (...) (27 years ago, 27-Oct-97, to lugnet.robotics.handyboard)
|
