|
|
 | | Re: digital ins
|
| (...) 5.12 volts (...) Yes. (...) 5.12 volts max, 0 volts minimum (...) The correct solution to your problem is to use an op-amp signal conditioner, possibly feeding into a schmidt trigger if you need some hysteresis. (sp?) You can also rig a zener (...) (27 years ago, 26-Aug-97, to lugnet.robotics.handyboard)
| | | | | Adding to the data bus
|
| After looking at the addressing scheme on the handyboard and determining it is possible to add a number of more outputs and inputs by extending the data lines to another board and using the free lines comming from the 74hc138. I built a robot arm (...) (27 years ago, 26-Aug-97, to lugnet.robotics.handyboard)
| | | | | digital ins
|
| Hi all, At what voltage on the digital ins does one risk damaging the HB? I want to feed an amplified signal to the digital ins on my HB to exaggerate the response of a photosensor in the 2-3V range of its operation. Unfortunately, this means that (...) (27 years ago, 26-Aug-97, to lugnet.robotics.handyboard)
| | | | | IC memory usage
|
| (...) IC 3.1's pcode is structured the same way. -- Randy ---...--- Randy Sargent Newton Research Labs Senior Design Engineer Robotic Systems and Software rsargent@newtonlabs.com (URL) (27 years ago, 26-Aug-97, to lugnet.robotics.handyboard)
| | | | | Re: free memory
|
| (...) Hi, I've just been working on the p-code interpreter. I've been working with the Version 2.861, not the HandyBoard version. But I did a "diff" and there doesn't seem to be much difference. At any rate, here's the map I made for Version 2.861: (...) (27 years ago, 26-Aug-97, to lugnet.robotics.handyboard)
|
|
