|
| | Re: Hall Effect Trans.
|
| I'd like to hear what you come up with as well. Presently I just use the magnet/coil sensor pairs that you can buy in any bike store. You just hook the shield to ground, and the other wire to, say, an input-capture pin of a 68HC11, with a 3.3 K pull (...) (27 years ago, 11-Aug-97, to lugnet.robotics.handyboard)
| | | | Re: Hall Effect Trans.
|
| I'd like to hear what you come up with as well. Presently I just use the magnet/coil sensor pairs that you can buy in any bike store. You just hook the shield to ground, and the other wire to, say, an input-capture pin of a 68HC11, with a 3.3 K pull (...) (27 years ago, 11-Aug-97, to lugnet.robotics.handyboard)
| | | | Thanks fro the reply...
|
| Well, so thanks fro your reply, you make feel live. You are rigth , Fred are right and so chuck are rigth.I'm very obsesive and may be not exist a answer short to my questions , sorry for my self. Your answer is very useful for my, but i don't know (...) (27 years ago, 11-Aug-97, to lugnet.robotics.handyboard)
| | | | More juice
|
| Can you parallel a 9.6v eight pack NiCad cell to the HB Nicad pack? Has anyone done this with success? If so, does it charge properly? jm (...) (27 years ago, 11-Aug-97, to lugnet.robotics.handyboard)
| | | | re: magnetic card readers
|
| dear german, i think what's going on is that you are asking very open-ended questions that require a lot of work to compose a helpful response. if i remember right, your earlier question was with regard to networking using the spi port of long (...) (27 years ago, 10-Aug-97, to lugnet.robotics.handyboard)
| |