 | | Re: News article about AFOL (from RTL)
|
|
(...) AFA my limited knowledge goes, it refs to countries south of the Mason-Dixon line (did I get that right?). XFUT .dixielug 'cause they would know best... -Shiri (25 years ago, 24-Apr-00, to lugnet.general, lugnet.org.us.dixielug)
|
|
 | | Re: Ultrasonic Mapping Robot
|
|
Resolution at 30 ft is 0.9 inches. At 90 ft, it is 3.2 inches. Bob Highfill ----- Original Message ----- From: James Pritchard <dungeon@madasafish.com> To: <lego-robotics@crynwr.com> Sent: Monday, April 24, 2000 2:59 PM Subject: Re: Ultrasonic (...) (25 years ago, 24-Apr-00, to lugnet.robotics)
|
|
 | | Re: News article about AFOL (from RTL)
|
|
Actually, "Dixie" is in reference to banknotes issued in Louisiana with "dix" (French for 'ten') on them. This actually predates Mason and Dixon by several decades. -Cheese (...) (25 years ago, 24-Apr-00, to lugnet.org.us.dixielug)
|
|
 | | Re: News article about AFOL (from RTL)
|
|
(...) Originally, yes, I believe so (Dixie is a reference to the Dixon part of the Mason-Dixon Line, IIRC). However, Maryland does not consider itself "Dixie", nor does Virginia, AFAIK. To me, "Dixie" refers to Georgia and Alabama, mostly. Jeff (25 years ago, 24-Apr-00, to lugnet.org.us.dixielug)
|
|
 | | Re: News article about AFOL (from RTL)
|
|
(...) Yes, I read LUGNET. And the "club" referred to is LUGOLA (LEGO User Group of Los Angeles)--the other two attending members being Dave Johann and Rick Kujawa. (...) Yes, I agree. I mentioned LUGNET to the writer, as well, I was contacted due to (...) (25 years ago, 24-Apr-00, to lugnet.general)
|
|
 | | Re: next Lugola meeting
|
|
I'm free to host a meeting on any weekend in May. Shall we say Saturday the 27th? And we can start it earlier than 3:00. All suggestions welcome. Henry (...) (25 years ago, 24-Apr-00, to lugnet.org.us.lugola, lugnet.loc.us.ca.la)
|
|
 | | New truck design... need help
|
|
Hi All, I tried a new truck design and need some help, pls look at the instructions at the URL: (URL) 3: shows the air tanks attached to the 1x2 single stud plate however... Step 6: shows a 2x4 plate "covering" the 1x2 single stud plate but it does (...) (25 years ago, 24-Apr-00, to lugnet.trains)
|
|
 | | Re: New Ship: "Mosquito" Fighter/Bomber
|
|
Thanks a lot Jim, I first built the bomb caches, and then saw that I could add the wings on the side, and yada, yada, yada, ended up with the "Mosquito"! Hope that was as vague as it could be... ;-) (...) (25 years ago, 25-Apr-00, to lugnet.build)
|
|
 | | Re: New truck design... need help
|
|
Hi, If you use a piece(or two) of tubing (found in any pneumatic sets) you can squeeze it in and that will hold the air tank firmly. Eric. (...) (25 years ago, 25-Apr-00, to lugnet.trains)
|
|
 | | Upcoming Terms of Use Agreement change
|
|
All, It's long been a point of confusion in the LUGNET Terms of Use Agreement, (URL) or not non-auction market traffic is permitted or verboten in non-market groups. The agreement doesn't specifically state that non-auction flogs (i.e., (...) (25 years ago, 25-Apr-00, to lugnet.admin.terms, lugnet.admin.general, lugnet.announce) !
|