Subject:
|
Re: New truck design... need help
|
Newsgroups:
|
lugnet.trains
|
Date:
|
Tue, 25 Apr 2000 00:05:16 GMT
|
Viewed:
|
2234 times
|
| |
|
|
Hi,
If you use a piece(or two) of tubing (found in any pneumatic sets) you can
squeeze it in and that will hold the air tank firmly.
Eric.
In lugnet.trains, Steven Barile writes:
> Hi All,
> I tried a new truck design and need some help, pls look at the instructions at
> the URL:
>
> http://www.sstanamera.com/~sebarile/LEGO/instructions/trucks/URT_Truck.htm
>
> Step 3: shows the air tanks attached to the 1x2 single stud plate however...
>
> Step 6: shows a 2x4 plate "covering" the 1x2 single stud plate but it does not
> firmly hold the air tank in place. The space between the top of the stud and
> bottom of 2x4 plate is about 1/2 a plate, thus allowing the air tank to simply
> lift out :(
>
> Anyone have an idea how to wedge it in, with out mutilations...
>
> SteveB
> PNLTC
|
|
Message is in Reply To:
 | | New truck design... need help
|
| Hi All, I tried a new truck design and need some help, pls look at the instructions at the URL: (URL) 3: shows the air tanks attached to the 1x2 single stud plate however... Step 6: shows a 2x4 plate "covering" the 1x2 single stud plate but it does (...) (26 years ago, 24-Apr-00, to lugnet.trains)
|
6 Messages in This Thread:
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
