|
|
 | | Re: (BrainDead) servos
|
| Please see the Servo page, linked off of the Software Resources page: (URL) you load the drivers, and connect the servo to power, ground, and a control output. -Fred In your message you said: (...) (28 years ago, 15-Jan-97, to lugnet.robotics.handyboard)
| | | | | Re: (BrainDead)
|
| (...) there 's one little mistake here.. you do not only need the servo.c file, but also the servo.icb file...So first you have to load the servo.icb file an then the servo.c file to get the thing working... Now you can use the servo commands as (...) (28 years ago, 15-Jan-97, to lugnet.robotics.handyboard)
| | | | | (BrainDead)
|
| I'm kind of stuck, and hopefully someone can tell me what I'm doing wrong. My group and I have been working with the HB for a couple of weeks now and have progressed to the point (in programming the HB) where we've written programs utilizing muliple (...) (28 years ago, 15-Jan-97, to lugnet.robotics.handyboard)
| | | | | (IR sensors)
|
| Can some give me a suggestion as to what kind of IR sensors would be good to use in conjunction with the Handboard on a mobile robot. I remember seeing some info on Sharp IR modules...and if I'm not mistaken, the posting mentioned that these IR (...) (28 years ago, 15-Jan-97, to lugnet.robotics.handyboard)
| | | | | (2 sensors)
|
| Tom, With regards to your writing the program that compared two sensors...may I ask what specific sensors were you using? or had in mind?? Jim Tegarden (28 years ago, 15-Jan-97, to lugnet.robotics.handyboard)
|
|
