 | | Re: Space stations?
|
| (...) I haven't built a fully working model yet, but have played with the mating slopes on either side of the door. I found that to get a good mate between the two sides, the female portion must be one plate taller than the male. In doing so, the (...) (25 years ago, 23-Sep-99, to lugnet.space)
| | | | | Re: Space stations?
|
| (...) Oops. Erg. This is not easily resolved. Drat. The indented/extended portions could be changed to use bricks and tiles, instead of slopes. Or we could keep the surfaces flat, like the M3 port. Steve (25 years ago, 24-Sep-99, to lugnet.space)
| | | | | Re: Space stations?
|
| (...) My vote is for the flat faced design. It generally takes up less room and (I think) is easier to incorporate into a design. Have you tried using a 2 x 1 x 1 panel instead of the 1 x 1 w/ headlight and tile design? I vaguely (sp) remember using (...) (25 years ago, 24-Sep-99, to lugnet.space)
| | | | | Re: Space stations?
|
| (...) It does stick a bit. The M3 uses the 1x2x1 panel you're talking about to secure the slide door at the top and bottom. Don't bother with LDraw unless you want to, cuz it's downloadable from my M3 page. Tonite and tommorrow I'm going to play (...) (25 years ago, 25-Sep-99, to lugnet.space)
| | | | | Re: Space stations?
|
| (...) I have them in the remains of my Deep Space Research vessle. They are integrated into the control center bulkhead. Other than what was posted in the ideas group, I haven't posted anything else. I would like to LDraw what I have left of the (...) (25 years ago, 27-Sep-99, to lugnet.space)
| |
