 | | Re: Multiplexing 4 touch sensors on an RCX input port
|
|
(...) LEGO purists use LEGO light bricks as resistors. I created potentiometer bricks, where the resistance is variable for each brick. Two stacks of 4 potentiometer bricks can be seen to the left of the RCX. In this case each stack puts the (...) (21 years ago, 9-Sep-03, to lugnet.robotics.rcx)
|
| |
| | Re: Multiplexing 4 touch sensors on an RCX input port
|
|
(...) I don't think that would work very well, as the lights have a rather low resistance, lower than a pressed touch sensor ((URL) as a purist you can use the cybermaster sensors to multiplex three inputs ((URL) Jürgen Stuber <stuber@loria.fr> (...) (21 years ago, 9-Sep-03, to lugnet.robotics.rcx)
|
| |
| | Re: Multiplexing 4 touch sensors on an RCX input port
|
|
(...) I have tried this method too, and as you say in your text, it is plagued by the rubber contacts whose value goes down as more pressure is applied to the switch. I measured resistance of several touch sensors while applying a very progressive (...) (21 years ago, 11-Sep-03, to lugnet.robotics.rcx)
|
| |
| | Touch Sensor resistance versus button displacement
|
|
Here is a chart showing the variation of contact resistance of several touch sensors while pressing button very progressively. (URL) There are huge differences between various sensor Lightly pressed touch sensors have contact resistance in the 2 to (...) (21 years ago, 11-Sep-03, to lugnet.robotics.rcx, FTX)
|
