|
| | Re: *** MLCad V3.40 ***
|
| (...) Thanks Mike! Like the others, I too really appreciate the undo functionality (even slow is better than none!) Cheers, Matija (12 years ago, 16-Jan-12, to lugnet.cad.mlcad)
| | | | Re: *** MLCad V3.40 ***
|
| (...) Apparently the problem still exists. It makes editing Datsville more difficult at times. Mike H (12 years ago, 8-Jan-12, to lugnet.cad.mlcad)
| | | | Re: *** MLCad V3.40 ***
|
| Thanks, Michael. Very much appreciated. Cristian www.brickinitalia.org (12 years ago, 1-Jan-12, to lugnet.cad.mlcad)
| | | | Re: *** MLCad V3.40 ***
|
| (...) To err is human, to undo is divine ;-) Thanks, Happy New Year /Lars (12 years ago, 31-Dec-11, to lugnet.cad.mlcad)
| | | | Re: *** MLCad V3.40 ***
|
| (...) I haven't installed the program yet to check... But in the previous version there was a problem when referencing a MPD file from inside another LDR or MPD file. I mean, let's say you have CAR.LDR and it references WINDSHIELD.MPD. Then, the (...) (12 years ago, 29-Dec-11, to lugnet.cad.mlcad)
| | | | Re: *** MLCad V3.40 ***
|
| (...) Undo Joy! thanks again Michael! Mike (12 years ago, 29-Dec-11, to lugnet.cad.mlcad)
| | | | Re: *** MLCad V3.40 ***
|
| (...) Thanks, Michael. Very much appreciated. Tim (12 years ago, 29-Dec-11, to lugnet.cad.mlcad)
| | | | Re: *** MLCad V3.40 ***
|
| Hello Michael, Highly appreciated (especially the undo!!!), a nice X-mas present for LDraw community. One small problem, in position/orientation dialog it seems that I can't check "Use rotation vector value"? Any hint? Philo (12 years ago, 28-Dec-11, to lugnet.cad.mlcad)
| | | | *** MLCad V3.40 ***
|
| Hello all, I would like to announce that there is a new version of MLCad available! MLCad V3.40 What's new: - Implemented basic undo functionality (might be a bit slow, but should work) - Improvements for network installation or installation under (...) (12 years ago, 27-Dec-11, to lugnet.cad.mlcad) !
| | | | Re: MLCad rotaton point?
|
| (...) Okay, in MLCad (and possibly other LDraw GUIs), an individual part will rotate around its origin point. On any standard brick/plate/tile, this origin point is typically found in the exact center of the top surface, excluding any studs. So if (...) (13 years ago, 2-Oct-11, to lugnet.cad.mlcad)
| |