To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.cad.lddOpen lugnet.cad.ldd in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 CAD / LDD / 82
81  |  83
Subject: 
Re: LDD 2.0 immedeately locks up
Newsgroups: 
lugnet.cad.ldd
Date: 
Thu, 29 Mar 2007 09:05:25 GMT
Viewed: 
32947 times
  
In lugnet.cad.ldd, Jeff Szklennik wrote:
   In lugnet.cad.ldd, Jason Allemann wrote:
   In lugnet.cad.ldd, Ross Crawford wrote:
   In lugnet.cad.ldd, Jeff Szklennik wrote:

SNIP

I got it to work fine by doing what Brad74 on the Lego.com forums said:

http://club.lego.com/messageboards/ShowPost.aspx?PostID=1000188413&PageIndex=2

“I had the same issues with v2.0 Stalled at the initial selection screen. I did however get it working. What I did was after initial install I un-checked the run LDD now box and clicked on the link to update Quicktime even though I was running a very recent version. I am not sure why but after updating Quicktime and restarting my computer everything runs fine. However it is too bad that some bricks are no longer available and two models my son and I built now can not be ordered without major re-works... Not appreciated mostly because these were some very integral pieces to our models.”

once i loaded the QT (unfortunately i couldn’t find a link on Apple.com for QT 7.1.5 WITHOUT iTunes) i was able to start LDD 2.0 & select a building starting point (starter model, freeplay, etc.) & loaded & played with no delay.

Thanks for the info - in a coincidental sequence of events, QT informed me there was a new version and I had downloaded it, less than 24 hours after I had unsuccessfully tried LDD 2.0. Unfortunately, I hadn’t tried LDD again after installing the new version of QT. LDD 2.0 now appears to work fine on my PC too, I will report here if I have any further issues.

ROSCO



Message is in Reply To:
  Re: LDD 2.0 immedeately locks up
 
(...) SNIP I got it to work fine by doing what Brad74 on the Lego.com forums said: (URL) "I had the same issues with v2.0 Stalled at the initial selection screen. I did however get it working. What I did was after initial install I un-checked the (...) (17 years ago, 29-Mar-07, to lugnet.cad.ldd, FTX)

8 Messages in This Thread:



Entire Thread on One Page:
Nested:  All | Brief | Compact | Dots
Linear:  All | Brief | Compact
    

Custom Search

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR