Subject:
|
12v Signals
|
Newsgroups:
|
lugnet.trains
|
Date:
|
Tue, 16 Jan 2001 20:40:00 GMT
|
Reply-To:
|
mpratt@cix.co.%StopSpam%uk
|
Viewed:
|
485 times
|
| |
|
|
Hello folks...
I have a 12v stop/start switch with remote control
set number 7860.
Does any one know how to wire one of these up ?
I did not get any plans and there are none on brickshelf.
Michael Pratt
|
|
Message has 2 Replies:
 | | Re: 12v Signals
|
| If memory serves me correct, on the rear of the switch there should be two terminals. When loking at the back straight on; the left hand side one serves as the wire to the signal, and the right hand one is connection to a special track piece in (...) (24 years ago, 16-Jan-01, to lugnet.trains)
|
3 Messages in This Thread:
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
