Subject:
|
Re: Railroad Dilemma
|
Newsgroups:
|
lugnet.trains
|
Date:
|
Thu, 25 Feb 1999 02:08:09 GMT
|
Viewed:
|
4200 times
|
| |
|
|
Ben,
Thanks Ben. I will try it out tonight. In question 2, I was just saying
if I ran one train around track#1, and had the switch going to track#2
(and not having the controller on, all the trains would be switched
off), would it cause a problem, or would it just be considered another
piece of track to go on.
I will let you know! Thanks again!
Scott Sanburn
Ben Fleskes wrote:
>
> All,
>
> see my comments below prefixed with 'ben>>'
>
> Scott Edward Sanburn writes:
> > That sounds great Matt, in regards to TD3!
> >
> > I guess my biggest concern involving the train situation is I would like
> > to have one switch rail between two lines or different tracks, each
> > having its own controller. I have a few questions regarding this
> > situation, I don't want to risk blowing anything up! :(
>
> ben>> Lego trains seem pretty blow up proof, but I'll keep trying. If I find a
> way to blow them up using only Lego pieces, I'll let you know.
>
> >
> > 1) Can a switch exist between two separate lines with two different
> > controllers?
>
> ben>> Yes. Simply be careful not to cause a short.
>
> >
> > 2) If so, is it possible to run just one controller for one train on the
> > same line if the switch is going to the other line? (I think it can)
>
> ben>> Not sure what you mean. The train will simply respond to the voltage it
> sees. If by switching the switch to the other line, you eliminate voltage to
> the part of track the train is on, the train will stop.
>
> >
> > 3) Along the same lines, can I have both controllers operating if the
> > switch is not connecting the two?
>
> ben>> Yes.
>
> >
> > 4) Lastly, what would happen if I had both controllers running at the
> > same time with the switch connecting them is active (both would be
> > connected.)
>
> ben>> You have essentially connect both loops in parallel with two parallel
> power supplies. If the two controllers have opposite polarity you have a
> problem, which will cause a fault and stop the motor and possibly damage the
> motor if the situation lingers. If both controllers have the same polarity,
> both trains will run with an amount of voltage from summing the addative powers
> of the two power supplies. Note: since they are in parallel it is not a simple
> 1+2=3 scenario. The formula escapes me but is a little more complicated.
>
> <snip>
>
> ben>> hope this helps.
|
|
Message is in Reply To:
 | | Re: Railroad Dilemma
|
| All, see my comments below prefixed with 'ben>>' (...) ben>> Lego trains seem pretty blow up proof, but I'll keep trying. If I find a way to blow them up using only Lego pieces, I'll let you know. (...) ben>> Yes. Simply be careful not to cause a (...) (28 years ago, 25-Feb-99, to lugnet.trains)
|
21 Messages in This Thread:
  
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
