| |
That would apply to shades of gray as well. I would suspect that printing
pink or yellow or light blue on a sticker that goes over a black piece will
likely have some color bleed through, also.
Why not just print the sticker on white adhesive paper and then cut very
carefully along the lines?
Mike
sebarile-MOBL <steve.e.barile@intel.com> wrote in message
news:Fp0nqI.J2w@lugnet.com...
> Some bad news...
> As you all may know PNLTC has recently adopted a new logo
> (http://www.pnltc.org/New%20PNLTC%20Logos/PNLTC_logos.htm)
> We found that any logo with "white" in it has trouble! Most (99%) printers
> don't print white. So if you are going to print this on to clear • stickers...
> The white comes out clear thus becoming the color that the sticker is • adhered
> to ;(
> SteveB
>
>
>
> In lugnet.org.us.baylug, Mike Poindexter writes:
> > I will fix that. Todd had mentioned it to me earlier, so I will just • change
> > it next time I work on the graphic file.
> >
> > Thanks,
> > Mike
> >
> > Russell Clark <rclark@telis.org> wrote in message
> > news:Fp0Kny.4yr@lugnet.com...
> > > In lugnet.org.us.baylug, Mike Poindexter writes:
> > >
> > > > The gif file needs a little bit of work on the right edge, but I just
> > > > cropped it from a screen dump, so I will fix it later. I think it is • a
> > > > little better than the first one I made. Let me know what you think.
> > >
> > > I just noticed something. It may be that I don't know the difference, • but
> > > doesn't LEGO have a ® "circle R" after it and not the T "TM"?
> > >
> > > Russell
|
|
Message has 1 Reply:
Message is in Reply To:
8 Messages in This Thread:
 
  
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
