To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.trainsOpen lugnet.trains in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Trains / 3101
3100  |  3102
Subject: 
Re: Wild West Trains posted!
Newsgroups: 
lugnet.trains
Date: 
Sat, 11 Dec 1999 20:54:53 GMT
Reply-To: 
LPIENIAZEK@NOVERA.COMstopspam
Viewed: 
865 times
  
Dan wrote:

These are more toylike than I care for (1) but there's artistry in them.

These trains are actually modelled on real 19th century American Civil War era
locomotives.

Well, actually, I'd tend to disagree. By the onset of the civil war,
many locomotives had switched to the 4-4-0 wheel arrangement and had
much longer boilers. Since the leading truck supported the smokebox,
most of the boiler would be out from under the cab.

Hence they'd be significantly longer. Almost twice as long
proportionally as yours compared to the tender length

The only locomotives using boilers as short as yours would be quite a
bit older, 1840s era locomotives near the end of their useful lives by
1860, and thus confined to switching or yard service. Not likely to be
found pulling a troop train in wild country.

Take a look at the photos of the golden spike ceremony. These are
archetypical civil war era locomotives, even though the photo was taken
in 1869.

I'm actually hoping my dad will dig up his old HO scale locomotives so I can
copy some of them, inlcuding a 1940's era monster with 6 sets of drive wheels!

If you want to model a monster, model a Virginian triplex (2-8-8-8-0,
three articulated sets of drivers, 4 axles each) or the Jawn Henry. Or
even a big boy. But those aren't really doable due to curve radius.

--
Larry Pieniazek larryp@novera.com  http://my.voyager.net/lar
- - - Web Application Integration! http://www.novera.com
fund Lugnet(tm): http://www.ebates.com/ ref: lar, 1/2 $$ to lugnet.

NOTE: Soon to be lpieniazek@tsisoft.com :-)



Message has 2 Replies:
  Re: Wild West Trains posted!
 
(...) Actually all of the above are completely doable. When I built my locomotives I actually built a prototype with three articulated sets of drive wheels (in pairs, but bigger combinations are possible). I plan on building larger, "over the road" (...) (25 years ago, 12-Dec-99, to lugnet.trains)
  Re: Wild West Trains posted!
 
Larry Pieniazek wrote in message <3852BA1D.EEECFB3C@v...er.net>... (...) I remember always drooling over the big boy every time I picked up an AHM catalog. I've never broke down and bought one though, primarily because I've never been into big iron (...) (25 years ago, 12-Dec-99, to lugnet.trains)

Message is in Reply To:
  Re: Wild West Trains posted!
 
Sorry about the last "blank" post... had too much coffee this afternoon... (...) Yes the drive wheels on the locomotives are made with stacked pulleys, with rubber "tires" from the Twisted Time Train keeping it on the rails. One side has 3 pulleys (...) (25 years ago, 11-Dec-99, to lugnet.trains)

8 Messages in This Thread:



Entire Thread on One Page:
Nested:  All | Brief | Compact | Dots
Linear:  All | Brief | Compact

This Message and its Replies on One Page:
Nested:  All | Brief | Compact | Dots
Linear:  All | Brief | Compact
    

Custom Search

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR