 | | Re: Has Anyone Tried This and Will it Work?
|
|
(...) Another thing to try: Use the 9V motor to power the IR receiver, and run the PF motor from that. This would require the 9V motor to be disconnected (just use the pick-up), and you'd need to run the train controller at full speed, and make sure (...) (15 years ago, 12-Jun-09, to lugnet.trains)
|
| |
| | Re: Has Anyone Tried This and Will it Work?
|
|
(...) I just tried this out on my basement layout. The short answer is no. The 8866 motor has a 9v-style connector on it, so the first thing I tried was connecting a 9v motor to the new motor with a 9v cable. No luck. Next, I tried connecting the 9v (...) (15 years ago, 12-Jun-09, to lugnet.trains)
|
| |
| | Re: Has Anyone Tried This and Will it Work?
|
|
(...) I had a similar idea a couple months ago, but it was more in terms of making 9v steam trains more bump-resistant. See, we did a layout earlier this year where our tables weren't 100% perfectly level. One of the guys had a steam train, which, (...) (15 years ago, 11-Jun-09, to lugnet.trains)
|
| |
| | Re: Has Anyone Tried This and Will it Work?
|
|
(...) I think the real intent was not so much installing a second motor, but actually powering the PF motor, or even a second PF motor from the 9V rail. Using the 9V truck to pick up power from the track and using the 8886 extension wire to convert (...) (15 years ago, 11-Jun-09, to lugnet.trains)
|
| |
| | Re: Has Anyone Tried This and Will it Work?
|
|
(...) Interesting idea, Clifton. I would be very interested to see if this works and if it is 'safe' for the motors. One thing to keep in mind though is that 9V motor failure tends to be more tied to the internal power leads that connect the wheels (...) (15 years ago, 11-Jun-09, to lugnet.trains)
|
