 | | Re: NSW Class 38 Streamlined steamer
|
|
(...) Nice to see you doing steam, one day you will do one without the fancy streamlining to show the greeble underneath ;-) The loco looks good, but I feel the streamlinedness is a bit understated, I'm sure you thought of it but I think a cone (...) (19 years ago, 16-Mar-06, to lugnet.trains, FTX)
|
| |
| | Re: NSW Class 38 Streamlined steamer
|
|
--SNIP-- (...) My L Class wasn't streamlined :P (...) I think the cone would be too pointy. The peak is surpringly blunt for a streamliner. I know what you mean about looking Russian. I think it might be the comparatively large boiler... and the (...) (19 years ago, 16-Mar-06, to lugnet.trains, FTX)
|
| |
| | Re: NSW Class 38 Streamlined steamer
|
|
(...) As per usual I forgot to say half I wanted to so... I also like the greebling on the front footplate below the boiler and use of the (URL) Technic Beam 2 with Two Antistuds' (32530)> in the cylinders, coincidentally I was thinking of using (...) (19 years ago, 16-Mar-06, to lugnet.trains, FTX)
|
| |
| | Re: NSW Class 38 Streamlined steamer
|
|
(...) It is there for the working pistons I never added ;) (...) That is actually the second iteration of the boiler. The first used macaroni but I felt it was a little too blocky. (...) (URL) They did>. It got spotlighted. You forgot to put it up. (...) (19 years ago, 16-Mar-06, to lugnet.trains, FTX)
|
| |
| | Re: Flex parts (Was NSW Class 38 Streamlined steamer)
|
|
(...) Hmm, perhaps there a range of parts I should CAD. The flex rods are pretty simple and the tube is already done. The (URL) older type >of connector is in the Parts Tracker, as is the (URL) ball version>. The (URL) newer pin connectors> are (...) (19 years ago, 16-Mar-06, to lugnet.trains, lugnet.cad.dat.parts, FTX)
|
| |
| | Re: NSW Class 38 Streamlined steamer
|
|
(...) Sorry Esben (URL) Fixed Tim (19 years ago, 16-Mar-06, to lugnet.trains, FTX)
|
| |
| | Re: NSW Class 38 Streamlined steamer
|
|
(...) Hey Tim, What do you mean "fixed"? I still don't see the train on the side bar :-) And Tim, that is, the other one, Timothy Gould, I've been following your creations lately, and I must say, they rock! But CAD pictures will never bee the same (...) (19 years ago, 16-Mar-06, to lugnet.trains, FTX)
|
