 | | Help with short circuit —Mitchell Lichtenberg
|
| | | Here's the layout: an oval with a left and a right hand turnout. The turnouts turn into the oval and are connected with track. Nothing complicated here. If I switch both turnouts to the inside I get a short. If I switch only one to the inside and (...) (19 years ago, 7-Jun-05, to lugnet.trains)
|
| | | |
| | | | | Re: Help with short circuit —Ross Crawford
|
| | | | (...) If you're getting a short, then you have a reversing loop. I'm guessing it looks something like this: /----\ | _/ If so, you definitely have a reversing loop. You can work around it by insulating the inside section of track completely and (...) (19 years ago, 7-Jun-05, to lugnet.trains, FTX)
|
| | | | |
| | | | | | Re: Help with short circuit —Mitchell Lichtenberg
|
| | | | (...) Rosco, Thanks. Maybe it is working the way you describe. But in your diagram you have two left hand switches. I have a right and a left so my diagram would make the internal track look like an upside down 'V' rather than a diagonal slash. If (...) (19 years ago, 7-Jun-05, to lugnet.trains, FTX)
|
| | | | |
| | | | | | Re: Help with short circuit —Ross Crawford
|
| | | | | (...) Well in that case, I stand corrected - it is not a reversing loop and should work fine. It should not short at all. If it is, I would suggest replacing the points, as they are likely to be the cause of the short. ROSCO (19 years ago, 7-Jun-05, to lugnet.trains, FTX)
|
| | | | | |
| | | | | | Re: Help with short circuit —Ed McGlynn
|
| | | | (...) Mitch - You're seeing a feature of the selection of the switches, and the train won't derail if the switch is set against the direction of travel. See (URL) for more details on how switches work. Switches direct trains and current, so if you (...) (19 years ago, 7-Jun-05, to lugnet.trains)
|
| | | | |
| | | | | | Re: Help with short circuit —Jason J. Railton
|
| | | | (...) There's a simple way to tell if it's a short, or just loss of power. If you get a short circuit, the green light on the controller goes very dim. If it's just that no power is getting to the track, your motor may stop moving but the controller (...) (19 years ago, 8-Jun-05, to lugnet.trains)
|
| | | | |
