Subject:
|
Re: 10170 TTX Intermodal Double-Stack Car Preview
|
Newsgroups:
|
lugnet.trains
|
Date:
|
Wed, 4 May 2005 18:40:48 GMT
|
Viewed:
|
9499 times
|
| |
|
|
In lugnet.trains, Larry Pieniazek wrote:
>
> One other thing I have toyed with is using a 1x2 technic brick, sideways. There
> is just enough of a cut in shoulder there that the pin doesn't bind the way it
> does in two plates. However it doesn't allow that movement out of vertical that
> I think is so useful.
>
> But unless you're already building a sideways SNOT car (did that for a tanker,
> long long ago, not my best work) it's not particularly convenient or sturdy.
I used this part to atach a 9v train motor to a train baseplate, with the motor
centered on the wire hole. I wanted the motor closer to the center for a My
Train steam engine.
Mat
|
|
Message is in Reply To:
 | | Re: 10170 TTX Intermodal Double-Stack Car Preview
|
| (...) whew! (...) Na, I like them. (...) One other thing I have toyed with is using a 1x2 technic brick, sideways. There is just enough of a cut in shoulder there that the pin doesn't bind the way it does in two plates. However it doesn't allow that (...) (20 years ago, 4-May-05, to lugnet.trains)
|
165 Messages in This Thread:
(Inline display suppressed due to large size. Click Dots below to view.)
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
