 | | Re: DCC chip installed in accessory brick —David Koudys
| | | | In lugnet.trains, Chris Phillips wrote: <snip> (...) Hey Chris, THere was a post a while back in which someone showed how to take the metal tabs out of the 2x8 brick---by taking a small drill and taking off the plastic holders. I did that for my (...) (21 years ago, 25-Nov-03, to lugnet.trains)
| | | | | | | | | | Re: DCC chip installed in accessory brick —Mark Riley
| | | | | (...) Dave, I don't know if you already did this, but before you glue it together, consider putting diodes in parallel with the light outputs. This will allow you to run inductive loads like motors and relays with the light outputs without fear of (...) (21 years ago, 25-Nov-03, to lugnet.trains)
| | | | | | |
