 | | Re: Combines and loads (was Re: New poster by Larry Pieniazek/MTW —Reinhard "Ben" Beneke
|
| | | (...) Mornin' Larry, [width of combine) (...) Ok, from the 1024x768 poster I was not too sure about it: I just saw the 6-wide cabin and the 2 studs mudgear on each side of it. Obviously these are wider than the body of the machinery. In this case I (...) (21 years ago, 16-Aug-03, to lugnet.trains)
|
| | | |
| | | | | Re: Combines and loads (was Re: New poster by Larry Pieniazek/MTW —Larry Pieniazek
|
| | | | (...) A bit of trickery there... :-) The cab is 6 wide at the top (the hinged part) but the stationary part is only 5 wide, using tiles to handle the mismatch. The stationary part sits on a 6 wide plate base which is offset 1/2 stud from the frame, (...) (21 years ago, 16-Aug-03, to lugnet.trains)
|
| | | | |
| | | | | | Re: Combines and loads (was Re: New poster by Larry Pieniazek/MTW —Reinhard "Ben" Beneke
|
| | | | (...) Can' wait to see some more detailed pictures of this model. Sounds by far more complicated as it seemed to be on the first view.... Ben (21 years ago, 16-Aug-03, to lugnet.trains)
|
| | | | |
