 | | questions about swapping rubber bands —Cary Clark
|
| | | In lugnet.trains, Reinhard "Ben" Beneke writes: ... (...) Last night I finally got around to filing down a few of my many defective wheel sets and successfully got a single Santa Fe engine (for the first time) to pull five stock Santa Fe cars around (...) (22 years ago, 2-Apr-03, to lugnet.trains)
|
| | | |
| | | | | Re: questions about swapping rubber bands —Reinhard "Ben" Beneke
|
| | | | | (...) Hi Cary, that sounds not to good... :-( (...) I always swapped all 4 rubber bands (at maybe 33% of all my motors - especially those that have not too much ballast but shall pull longer trains). (...) Only on 9V nowadays. In the past a few (...) (22 years ago, 2-Apr-03, to lugnet.trains)
|
| | | | | |
| | | | | Re: questions about swapping rubber bands —Ludo Soete
|
| | | | (...) Hi Cary, I remember that i got also once a problem with a 9V motor (from a new Metroliner set). I could replace him for a new one after contacting LEGO abouth it. The train could run for abouth 10 rounds and then stopped, but the light in the (...) (22 years ago, 7-Apr-03, to lugnet.trains)
|
| | | | |
