To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.trainsOpen lugnet.trains in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Trains / 18847
18846  |  18848
Subject: 
Re: Round parts on the side of ... (was Re: LEGO SW Haildire Droid will cost....
Newsgroups: 
lugnet.trains
Date: 
Mon, 6 Jan 2003 01:35:29 GMT
Viewed: 
1959 times
  
"Stefan Garcia" <sastrei@netscape.net> wrote in message
news:H89p1z.5Bt@lugnet.com...
I think it has teeth like those found on the bionicle double-bevel gears.
Might mesh, though I don't see any obvious connection points for anything
else like technic pins or rods.

<snip>

I think you are right Stefan. As for inside, yes it looks like there might be
gear teeth in there.

--
Thanx~
Nicole Drumm MS
http://www.geocities.com/duelarcane1/



Message has 1 Reply:
  Re: Round parts on the side of ... (was Re: LEGO SW Haildire Droid will cost....
 
Here is what I've calculated on this new component "gear wheel" (my calculations could be MILES off of correct, mind you): -Teeth count is approximately 96 on the outside. -Outside diameter is 24 studs -Inside diameter is 20 studs -The strip running (...) (22 years ago, 6-Jan-03, to lugnet.trains)

Message is in Reply To:
  Re: Round parts on the side of ... (was Re: LEGO SW Haildire Droid will cost....
 
I think it has teeth like those found on the bionicle double-bevel gears. Might mesh, though I don't see any obvious connection points for anything else like technic pins or rods. -Stefan- (...) (22 years ago, 6-Jan-03, to lugnet.trains)

17 Messages in This Thread:





Entire Thread on One Page:
Nested:  All | Brief | Compact | Dots
Linear:  All | Brief | Compact

This Message and its Replies on One Page:
Nested:  All | Brief | Compact | Dots
Linear:  All | Brief | Compact
    

Custom Search

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR