To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.trainsOpen lugnet.trains in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Trains / 17591
    Re: restoring, 9v, track —Wayne Sardullo
   I should have clarified this before writting. I use the below products on the metal rails of the track. Soap and water work on the plastic. (...) (22 years ago, 8-Sep-02, to lugnet.trains)
   
        Re: restoring, 9v, track —Kevin Salm
   (...) The timing of this thread is incredible!! (perhaps uncanny) -- since I was about to ask this same question. I know all about using alcohol from Wayne. So I tried a new household sponge soaked in 91% rubbing alchol (typical rubbing alchol is (...) (22 years ago, 10-Sep-02, to lugnet.trains)
   
        Re: restoring, 9v, track —Larry Pieniazek
   (...) Please do! (...) I'd advise using white (artgum) rather than pink, as pink has abrasive in it. If white works as well, you've saved abrading your track a bit. Abrasion, I would think, would increase the rate of subsequent dirt accretion. The (...) (22 years ago, 10-Sep-02, to lugnet.trains)  
   
        Re: restoring, 9v, track —Jan-Albert van Ree
   (...) The problem with any abrasive cleaning is that it leaves tiny grooves, causing the track to get dirty again even sooner... at least that's what I learned from/being a h0 railroader. (22 years ago, 10-Sep-02, to lugnet.trains)
 

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR