 | | Re: cramming details into 6 studs
|
|
I knew this would start a 6 vs. 8 debate... But that was not the goal of the initial post. The goal is to get some feedback on how this can be done in 6 wide. If there are no creative, cost effective solutions, then I will probably settle for a less (...) (24 years ago, 15-May-01, to lugnet.trains)
|
| |
| | Re: cramming details into 6 studs
|
|
Bryan Kinkel <helpdesk@loseyourmind.com> wrote in message news:GDDvG2.Lrv@lugnet.com... (...) the (...) there (...) a (...) my (...) 6 studs is the standard and I like to stick to that too. But in between they can be both 5 and 7 wide to fit (...) (24 years ago, 16-May-01, to lugnet.trains)
|
| |
| | Re: cramming details into 6 studs
|
|
(...) I build European prototype equipment, and to me 6 wide is just fine. I don't strive for lifelike realism in my MOC's, for this is one of the reasons I left N scale to begin with. The NMRA (and NEM) is full of those persons who wish to achieve (...) (24 years ago, 17-May-01, to lugnet.trains)
|
