 | | Chemical Tanker Cars - Rolling Stock
|
|
Hello again everyone! I finally got around to taking pictures of a lot of the MOC's I built this spring and summer for the two shows we did this year. This MOC is a few tanker cars I built based off of a design by James Mathis. The design is (...) (16 years ago, 24-Sep-08, to lugnet.announce.moc, lugnet.build, lugnet.trains, FTX)
|
| |
| | Re: My Train Yard...
|
|
(...) Very impressive, Mark. I don't have the patience or the bricks to multiply my freight cars that many time. (16 years ago, 22-Sep-08, to lugnet.trains, FTX)
|
| |
| | Re: My Train Yard...
|
|
(...) That my friend...is a lot of rolling stock. Very cool and thanks for sharing. -Dave ToT-LUG (16 years ago, 21-Sep-08, to lugnet.trains, FTX)
|
| |
| | My Train Yard...
|
|
(URL) (16 years ago, 21-Sep-08, to lugnet.trains, FTX)
|
| |
| | Re: Is there a reference site on motorized switchs
|
|
(...) Try these. There is some good information on all of them. (URL) FreeLUG Article on Motorized Points> (URL) Automated 9V Switch> (URL) Mark Riley's Solution> Good luck and happy building! -Dave ToT-LUG (16 years ago, 18-Sep-08, to lugnet.trains, FTX)
|
| |
| | Is there a reference site on motorized switchs
|
|
I thought I had found one once, but then seem to have lost track of it, HELP!! (16 years ago, 18-Sep-08, to lugnet.trains)
|
| |
| | Re: Automated Level Crossing using NXT
|
|
quite neat. I hope you can figure out the correct switching delays for the micromotor. Do you think this technique could be used to make a monorail level crossing ? Steve (16 years ago, 11-Sep-08, to lugnet.trains, FTX)
|
| |
| | ATSF Piggy-Back Service (Flatbed w/Truck Trailer) MOC
|
|
Here's my latest train MOC. This is an ATSF Piggy-Back Service train... (2 URLs) Here's the model it was based on: (URL) Mark (16 years ago, 9-Sep-08, to lugnet.trains, FTX)
|
| |
| | New Red Chemical Car
|
|
I managed to snag some rare dark red brick from a grab bag at the local Lego store. The dark red pieces are from set 7665 (Republic Cruiser). I then combined them with some extra train parts and you get what you see below. The end result was this (...) (16 years ago, 9-Sep-08, to lugnet.trains, FTX)
|
| |
| | Re: Automated Level Crossing using NXT
|
|
That is an excellent system for controlling train crossings. I love that it is all above the baseplates and only uses one motor for both crossings. I have two suggestions for the motor timing on raising and lowering of the gates: 1) Use a Technic (...) (16 years ago, 6-Sep-08, to lugnet.trains)
|
