 | | Re: Power Function control with RCX and BrickOS
|
|
(...) Bob, I could not wait to get home from work to try this. I want to say thank you; your effort has saved me many countless hours. I loaded the Firmware, and the Program into a 1.0 RCX, and the brick worked flawlessly! On my 1.0 brick, I was (...) (17 years ago, 26-Jan-08, to lugnet.general, lugnet.technic, lugnet.trains, lugnet.robotics)
|
| |
| | Re: Norfolk & Western Y6b 2-8-8-2 Steam Locomotive
|
|
(...) Cale: That is one sweet looking loco. :-) I happen to be a fan of the jagged boiler look. It gives it that strong, tough, and rough around the edges look. Very nice. I agree with Tony that 9-wide just sets this thing off. It really puts it in (...) (17 years ago, 26-Jan-08, to lugnet.trains, FTX)
|
| |
| | Re: Power Function control with RCX and BrickOS
|
|
(...) The toggle bit is checked in Single output mode (the documentation is not quite right for this mode) and in both single pin modes. each message is sent 5 times you need to toggle the toggle bit in every message sent. 0 1 0 1 0 1 0 1 etc. bob (17 years ago, 25-Jan-08, to lugnet.general, lugnet.technic, lugnet.trains, lugnet.robotics, FTX)
|
| |
| | Re: Norfolk & Western Y6b 2-8-8-2 Steam Locomotive
|
|
(...) Wow. Just... wow. I absolutely love this locomotive. Not just because it looks great, but because the way you've solved some problems I've run into in the past with attaching pilot and rear trucks. I've been drooling over this locomotive now (...) (17 years ago, 25-Jan-08, to lugnet.trains, FTX)
|
| |
| | Norfolk & Western Y6b 2-8-8-2 Steam Locomotive
|
|
Norfolk & Western Y6b 2-8-8-2 Steam Locomotive After tackling a few rigid frame steamers I decided for my next challenge to build an articulated. So I chose one of my favorite Mallets the (URL) N&W Y6b>. (3 URLs) Brickshelf Gallery> after (...) (17 years ago, 25-Jan-08, to lugnet.trains, lugnet.announce.moc, FTX) !!
|
