General Discussion : 54446


General / 54446	54445 \| 54447

Subject:	Re: Power Function control with RCX and BrickOS
Newsgroups:	lugnet.general, lugnet.technic, lugnet.trains, lugnet.robotics
Date:	Fri, 25 Jan 2008 23:41:58 GMT
Viewed:	19581 times

direct’. But I can’t get ‘Single output’ or either of the ‘Single pin’ modes to work. Have you had any more luck?

The toggle bit is checked in Single output mode (the documentation is not quite right for this mode) and in both single pin modes. each message is sent 5 times you need to toggle the toggle bit in every message sent. 0 1 0 1 0 1 0 1 etc.

bob

Message has 1 Reply:

		Re: Power Function control with RCX and BrickOS
(...) Okay, thanks. I can get 'Single output Mode' to work now. 'Single pin Mode' may be working too, but I'm not sure what to expect from it. I would expect setting either C1 or C2 would set them to 9V and run a motor forwards or backwards. Setting (...) (17 years ago, 26-Jan-08, to lugnet.general, lugnet.technic, lugnet.trains, lugnet.robotics, FTX)

Message is in Reply To:

		Re: Power Function control with RCX and BrickOS
(...) I don't have BrickOS, but I have been playing with the protocols in NBC. I got the twin-motor PWM mode to work in tests, and the original 'Combo direct'. But I can't get 'Single output' or either of the 'Single pin' modes to work. Have you had (...) (17 years ago, 25-Jan-08, to lugnet.general, lugnet.technic, lugnet.trains, lugnet.robotics, FTX)

17 Messages in This Thread:

Entire Thread on One Page:: Nested: All | Brief | Compact | Dots
Linear: All | Brief | Compact
This Message and its Replies on One Page:: Nested: All | Brief | Compact | Dots
Linear: All | Brief | Compact

Active threads in Robotics

	Verified and Trusted Team of Hackers 14 hours ago

Custom Search