| |
In lugnet.general, Bob Kojima wrote:
| |
| |
direct’. But I can’t get ‘Single output’ or either of the ‘Single pin’
modes to work. Have you had any more luck?
|
The toggle bit is checked in Single output mode (the documentation is not
quite right for this mode) and in both single pin modes. each message is
sent 5 times you need to toggle the toggle bit in every message sent. 0 1 0 1
0 1 0 1 etc.
bob
|
Okay, thanks. I can get ‘Single output Mode’ to work now. ‘Single pin Mode’
may be working too, but I’m not sure what to expect from it.
I would expect setting either C1 or C2 would set them to 9V and run a motor
forwards or backwards. Setting them both would stop it.
But it seems if I set them, they do nothing. Unless the motor is already
running. If it’s running forwards at slow speed, then I set C1, it jumps up to
full speed. But then if I set C2 it keeps running, and if I clear C1 it keeps
running, and in the same direction.
Can you get a motor to run just be setting C1?
Jason R
|
|
Message has 1 Reply:
Message is in Reply To:
17 Messages in This Thread:
   
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
Active threads in Robotics
|
|
|
|
|
|
