 | | Re: 7-Wide BNSF & TTX Intermodal Train & Crane
|
|
(...) I'm ignoring the IR bulge, as well. But, here is another try at it: (URL) fence method probably has interference with the fact that a stud height would interfer-- it doesn't in CAD, but we remember that studs are greater than 1/2 plate thick, (...) (20 years ago, 28-Jun-06, to lugnet.trains)
|
| |
| | Re: 7-Wide BNSF & TTX Intermodal Train & Crane
|
|
A way to overcome the problem of the offset studs on top of the brackets would be placing a (URL) Slope 65 2 x 2 x 2 Smooth without Bottom Tube> over each of them (vertical face outwards) With friendly greetings, M. Moolhuysen. (20 years ago, 28-Jun-06, to lugnet.trains, FTX)
|
| |
| | Re: 7-Wide BNSF & TTX Intermodal Train & Crane
|
|
(...) Another side topic I have not noticed to be mentioned here in Lugnet is the following: (URL) These new wheels (as shown by Heiner Berg from his 7898 set) have no bore hole reaching through the wheel, but they have a plastic tip which will be (...) (20 years ago, 28-Jun-06, to lugnet.trains, FTX)
|
| |
| | Re: 7-Wide BNSF & TTX Intermodal Train & Crane
|
|
PS. And we're both ignoring the IR battery box in the centre which also has to be worked around. (20 years ago, 28-Jun-06, to lugnet.trains)
|
| |
| | Re: 7-Wide BNSF & TTX Intermodal Train & Crane
|
|
(...) Hi David, I've actually tried something similar to that before but didn't like the studs. The other problem with it is that it may not work since real studs are a little taller than half a plate. The best I've come up with so far is something (...) (20 years ago, 28-Jun-06, to lugnet.trains)
|
