 | | Progress with DCC and PC
|
|
I am finally making progress with my project to control DCC systems from a PC. There are systems out there but I wanted to do my own. My idea has been to generate the DCC packets in the sound card and I have finally managed a reasonably simple (...) (22 years ago, 14-Jan-03, to lugnet.trains)
|
| |
| | Re: B&O V-2 Hudson Steam Engine
|
|
The pilot truck pivots behind the second axle of the pilot truck and the trailing truck pivots in front of the first axle of the trailing truck. This makes the pivots points as close as possible to the drivers so they do not swing so much. The (...) (22 years ago, 13-Jan-03, to lugnet.trains)
|
| |
| | Re: B&O V-2 Hudson Steam Engine
|
|
OK, look before you post. Now I get it. I was so busy trying to fit what I was seeing into the floating truck solution that it didn't make any sense. Now I clearly see the pivot points etc. BTW can you post a couple pics of it sitting on a curve :) (...) (22 years ago, 13-Jan-03, to lugnet.trains)
|
| |
| | Re: B&O V-2 Hudson Steam Engine
|
|
I was wondering where your leading and trailing truck pivot points were. Are each of these pivot points still between the axles of the respective trucks or in front and behind? I'll also go back and look at your pics. Would you mind if I used this (...) (22 years ago, 13-Jan-03, to lugnet.trains)
|
| |
| | Re: B&O V-2 Hudson Steam Engine
|
|
(...) Yes, the drivers are attached to the frame, for the reasons Shaun explains above and because that's how the real ones are built. By making the pilot and trailing trucks pivot closely to the drivers, I was able to keep the drivers over the (...) (22 years ago, 13-Jan-03, to lugnet.trains)
|
