 | | Re: Union Pacific Caboose
|
|
I just figured out a simple little trick with this piece. If you add a 1x2 plate on the bottom it keeps the magnet-holder from spinning all the way to the side. Assuming you insert the magnet-holder from the bottom. SteveB (...) (23 years ago, 14-Jan-02, to lugnet.trains)
|
| |
| | Re: Remote Turnouts and Decouplers
|
|
(...) I also feel local loops are a good thing. PNLTC has been running several local loops also haven't they? Of course I'm doing local loops using 12v so I can do automated turnouts and block control without nearly so much work :-) (and I may one (...) (23 years ago, 14-Jan-02, to lugnet.trains)
|
| |
| | Re: Remote Turnouts and Decouplers
|
|
(...) This pic from David K shows the control panel. Switches marked with 2 1x2 tiles are turnouts... switches marked with just one 2x2 are decouplers. Check out the remote caddy at the far end for the Mindstorms IR remote. There are two speed (...) (23 years ago, 14-Jan-02, to lugnet.trains)
|
| |
| | RCX Controlled Special Loco with Decoupler
|
|
I made a speciaal Loco, it is 8-wide and controll by on board RCX with two geared motors, it will stop when back and IR sensor (made by John Barnes) detect train car, magnet will couple loco and train car, it also has a auto decoupler function, (...) (23 years ago, 14-Jan-02, to lugnet.trains, lugnet.robotics.rcx)
|
| |
| | Re: German Steam Engine BR50: MOC finished
|
|
Outstanding. Thanks for all the detail pics. later, James Mathis (...) (23 years ago, 14-Jan-02, to lugnet.trains)
|
