 | | Re: Trolley line automation
|
|
(...) Same here in Melbourne (Aus), up till a few years ago when the last of the "W" class trams (which had a pole either end) were retired from service. It's a bit hard to automate this on a Lego layout, but maybe not impossible. You have to worry (...) (23 years ago, 18-Aug-01, to lugnet.trains)
|
| |
| | BNSF Covered Hopper update
|
|
I've added a MLCAD 3-D image to the page: (URL) is your chanse to see what it will look like when i get finished. The unloading bays on the under side are made with 2x2 inverted 45 degree outside corner slopes, and technic pags holding the 1x2 plate (...) (23 years ago, 18-Aug-01, to lugnet.trains)
|
| |
| | Re: Mpegs uploaded for the TTOS Show!
|
|
(...) Just some information. I see that you use only 2 red LED's for the crossing signal. If you use the round 1x1 bricks, then you can pull the wires through the hole of these bricks. On the bottom, you can use a 2x4 technic plate to pass these (...) (23 years ago, 18-Aug-01, to lugnet.org.ca.vlc, lugnet.trains, lugnet.trains.org, lugnet.robotics)
|
| |
| | Re: Trolley line automation
|
|
I guess I am going to show my age here. In Los Angeles, in the forties, the trolleys had a pole on both ends and the conductor simply pulled one down and raised the other. He then sat in the seat at the other end of the car and went the opposite (...) (23 years ago, 18-Aug-01, to lugnet.trains)
|
| |
| | extra pate under 9V train wheels
|
|
Hi, I'm converting some 12V trains to 9V. To match the new motors as close as possable I want to have a plate _under_ the trainwheels. But while testing this 1 train had problems with a switch (it derailed) while an other didn't. Does anyone have (...) (23 years ago, 18-Aug-01, to lugnet.trains)
|
