Subject:
|
Re: Minifig scale Bulldozer
|
Newsgroups:
|
lugnet.technic
|
Date:
|
Fri, 24 Jan 2003 08:35:37 GMT
|
Viewed:
|
1120 times
|
| |
![Post a public reply to this message](/news/icon-reply.gif) | |
> I have a question: Is the 16t idler gear driven directly from the micro
> motor? I don't think I've ever seen that done before!
Yes it is, but I can't recall where I've found that assembly - I think
somewhere on Brickshelf.
It works quite good: the idler gear doesn't slip until you put a high load
on it, and the slipping prevents micromotor jamming. The drawback is that,
after slipping a bit, the gear tends to detach from the micromotor.
ciao
step
>
> ROSCO
|
|
Message has 1 Reply:
Message is in Reply To:
![](/news/x.gif) | | Re: Minifig scale Bulldozer
|
| (...) I have a question: Is the 16t idler gear driven directly from the micro motor? I don't think I've ever seen that done before! ROSCO (21 years ago, 24-Jan-03, to lugnet.technic)
|
7 Messages in This Thread: ![Minifig scale Bulldozer -Stefano Prosseda (23-Jan-03 to lugnet.technic)](/news/x.gif) ![](/news/246.gif) ![Re: Minifig scale Bulldozer -Simon Bennett (23-Jan-03 to lugnet.technic)](/news/x.gif) ![](/news/46.gif) ![Re: Minifig scale Bulldozer -Stefano Prosseda (23-Jan-03 to lugnet.technic)](/news/x.gif)
![](/news/x.gif) ![](/news/68.gif) ![Re: Minifig scale Bulldozer -Ross Crawford (24-Jan-03 to lugnet.technic)](/news/x.gif) ![](/news/46.gif) ![You are here](/news/here.gif) ![](/news/46.gif) ![Re: Minifig scale Bulldozer -Miguel Agullo (26-Jan-03 to lugnet.technic)](/news/x.gif) ![](/news/46.gif) ![Re: Minifig scale Bulldozer -Stefano Prosseda (28-Jan-03 to lugnet.technic)](/news/x.gif)
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|