To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.technicOpen lugnet.technic in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Technic / 862
    Re: removing a spring from the pneumatic pump —Philip Ogston
   (...) You can also do the same off the side of the shaft - a variation of Mr. Fay's technique which causes a bit less distortion. It's hard to describe, but if you get a thumbnail under the very end of the spring-wire, you can pull the end around (...) (25 years ago, 18-Jan-00, to lugnet.technic)
   
        Re: removing a spring from the pneumatic pump —Robert G. Fay
   Good idea, Phil. Definitely a less destructive way to do it. -- Bob Fay rfay@we.mediaone.net The Shop (URL) Ogston" <ogstonpj@worldnet.att.net> wrote in message news:FoI82r.I95@lugnet.com... (...) well. (...) Fay's (...) if (...) the end (...) have (...) (25 years ago, 18-Jan-00, to lugnet.technic)
 

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR