Subject:
|
Re: On LEGO Compressors & Pump Testing
|
Newsgroups:
|
lugnet.robotics, lugnet.technic
|
Date:
|
Sat, 23 Nov 2002 02:36:14 GMT
|
Viewed:
|
434 times
|
| |
|
|
Gaurav Thakur wrote:
>
> I actually did not known of the existence of the small pump at all until a
> couple of years ago and used to think that the large one was the only
> option. (the 8868 Airtech Claw Rig was not properly advertised in the US and
> I didn't hear about it until 2000) However, there is a pack of two available
> on the Dacta website for $10; I ordered one of those a while ago.
>
> By the way, here is the setup I am using at the moment. Does this look any
> good to you?
>
> http://www.brickshelf.com/gallery/CP5670/ATCR2/atcr2-03.jpg
Er, it's hard to tell just by looking at the picture. Besides it's kinda
dark and blurry. I see a lot of gears (linking the two motors?) and can
just make out the 4 small pumps.
How about separating the two motors so you get two independent
compressors each with two pumps. That way you could put each compressor
where you have space. Their compressed air output can of course be
joined together by the pneumatic tubing. Just a thought.
--
C S Soh
CSSoh's Lego Pneumatics
http://www.ozbricks.net/cssoh1
... where air is power!
|
|
Message is in Reply To:
 | | Re: On LEGO Compressors & Pump Testing
|
| (...) couple of years ago and used to think that the large one was the only option. (the 8868 Airtech Claw Rig was not properly advertised in the US and I didn't hear about it until 2000) However, there is a pack of two available on the Dacta (...) (22 years ago, 22-Nov-02, to lugnet.robotics, lugnet.technic)
|
9 Messages in This Thread:
  
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
Active threads in Robotics
|
|
|
|
|
|
