 | | Wiring Gear Motors —Greg Majewski
|
| | | Is it at all possible to wire a regular Lego gear motor to outside electronics? It seems like it could be done by cutting one end off of a Lego wire and reattaching other wires so that the motor could be plugged into something like a speed (...) (23 years ago, 30-Aug-01, to lugnet.technic)
|
| | | |
| | | | | Re: Wiring Gear Motors —Thomas (T. J.) Avery
|
| | | | | (...) Sure, you can wire it up to anything you want to. But do so at your own risk. I've used an AC adaptor (12V, 1A output) with my 9V motors for quite a while now and they work fine. My only advice would be to cut your Lego wires a good length (...) (23 years ago, 30-Aug-01, to lugnet.technic)
|
| | | | | |
| | | | | | | Re: Wiring Gear Motors —Jennifer Clark
|
| | | | | | (...) As I (and I'm sure John Barnes as well!) have found it is possible to take the end connector apart and fit the two way ribbon cable back into it again. I've used this technique to make several medium length cables from a bunch of very long and (...) (23 years ago, 12-Sep-01, to lugnet.technic)
|
| | | | | | |
| | | | | Re: Wiring Gear Motors —Robert Powell
|
| | | | (...) Hey Greg, If your looking to connect to a speed controller, you can use a LEGO 9v train controller. Other than that, sure, you can cut and splice to your hearts content. Robert Powell SCLTC (23 years ago, 31-Aug-01, to lugnet.technic)
|
| | | | |
| | | | | | Re: Wiring Gear Motors —Thomas (T. J.) Avery
|
| | | | (...) Or, you could go to your local Radio Shack and buy an AC to DC adapter with 9V output and a potentiometer for a lot less than the cost of a Lego train controller. :-) TJ -uh cuttin' and uh splicin' we go! (23 years ago, 31-Aug-01, to lugnet.technic)
|
| | | | |
