Subject:
|
Re: Impossible to take apart - reprise
|
Newsgroups:
|
lugnet.general, lugnet.technic
|
Date:
|
Sat, 16 Jun 2001 15:10:28 GMT
|
Viewed:
|
208 times
|
| |
|
|
In lugnet.general, Ronald Vallenduuk writes:
> After enjoying the discussion about the hard-to-take-apart cube I thought
> about some constuctions myself. Couldn't come up with something simple and
> elegant so far, however.......
> I'm just after taking the 8448.... almost. In the door-opening mechanism
> (wing door model) there's this combination of two pieces I haven't been able
> to take apart so far. I don't have a picture handy, so I'll describe them:
> two #5 half beams, one with five holes, one with four studs and a cross-hole
> in the middle. Put them together (with all the studs in the holes) and try
> to take apart (without pliers that is....).....
>
> Tips anyone ???
>
> Duq
I have had the exact same problem with that little assembly on the 8448
Super Street Sensation. Despite repeated attempts with pushing axle through
the holes I have not been able to pull the two elements apart yet. It's too
bad since I only have a few copies of one of those pieces. (the studded
plate with an axle insert)
-Gaurav Thakur, raving madman
Can be reached at cp5670@supermail.com
http://cp5670.terrashare.com/TC/
|
|
Message is in Reply To:
 | | Impossible to take apart - reprise
|
| After enjoying the discussion about the hard-to-take-apart cube I thought about some constuctions myself. Couldn't come up with something simple and elegant so far, however....... I'm just after taking the 8448.... almost. In the door-opening (...) (23 years ago, 11-Jun-01, to lugnet.general, lugnet.technic)
|
4 Messages in This Thread:
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
