Subject:
|
Re: Impossible to take apart - reprise
|
Newsgroups:
|
lugnet.general, lugnet.technic
|
Date:
|
Sat, 16 Jun 2001 14:28:56 GMT
|
Viewed:
|
199 times
|
| |
|
|
On Mon, 11 Jun 2001 00:38:48 GMT, "Duq" <Duq@nlgateway.net> wrote:
> I'm just after taking the 8448.... almost. In the door-opening mechanism
> (wing door model) there's this combination of two pieces I haven't been able
> to take apart so far. I don't have a picture handy, so I'll describe them:
> two #5 half beams, one with five holes, one with four studs and a cross-hole
> in the middle. Put them together (with all the studs in the holes) and try
> to take apart (without pliers that is....).....
Yes, that was a bit of a struggle, but try to stack two of the
"Bracket 5 x 2 x 2&1/3" togheter so that the 2x3 "plates" connects and
the 2x2 "plates" connect. They will be one stud offset.
Hum, this came otu to be hard to describe. Just put them togheter in
the way it feels best :) On top of each other so that they make a
thicker piece.
Here is what the one piece look like:
http://www.peeron.com/inv/parts/6087
I had more trouble to get those two apart and I recall regretting
putting them togheter in the first place.
On a second thougt, don't try this :)
/Tobbe
http://www.arnesson.nu/lotek/
|
|
Message is in Reply To:
 | | Impossible to take apart - reprise
|
| After enjoying the discussion about the hard-to-take-apart cube I thought about some constuctions myself. Couldn't come up with something simple and elegant so far, however....... I'm just after taking the 8448.... almost. In the door-opening (...) (23 years ago, 11-Jun-01, to lugnet.general, lugnet.technic)
|
4 Messages in This Thread:
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
