 | | Re: 120 degree connector —Wayne R. Hussey
| | | | (...) By using 3 of the 24-tooth gears set up into a triangle, you can set the angles at whatever multiple of 15 degrees you want. If you use the older gears, you get a direct connect to 4 peg-holes aligned for standard Technic building on one side (...) (23 years ago, 13-Jun-01, to lugnet.technic)
| | | | | | | | | | Re: 120 degree connector —David Arnon
| | | | | (...) I can't understand what you mean, can you post a picture or a sketch? Thanks, David (23 years ago, 14-Jun-01, to lugnet.technic)
| | | | | | | | | | | | Re: 120 degree connector —Wayne R. Hussey
| | | | | (...) David, The method I've described is complex. Maybe more so than you need. It can be done other easier ways, as shown by other postings. I will describe it in detail here and once you've seen it, can adapt or discard as you choose. If you want, (...) (23 years ago, 19-Jun-01, to lugnet.technic)
| | | | | | |
