LEGO TECHNIC : 4209


Technic / 4209	4208 \| 4210

Subject:	Guide to Control Lab
Newsgroups:	lugnet.dacta, lugnet.technic, lugnet.robotics.rcx.robolab
Date:	Thu, 8 Mar 2001 07:23:51 GMT
Viewed:	228 times

Hello, I have just bought a used Dacta control lab and I use it via an ActiveX that I found on the net. However there are some small details that I would like get cleared out. 1: What is the difference between the yellow and blue input connectors? 2: What is the stop button for? 3: How can/should the on connector be used 4: Is there any difference between the 8 output connectors. 5: Can I use an Mindstorms Light Sensor on the control lab? Hope anyone can answer these questions or guide me to a page where I can read about it. Lars Gertsen - Denmark

Message has 3 Replies:

		Re: Guide to Control Lab
"Lars Gertsen" <lars.gertsen@mail.tele.dk> wrote in message news:3AA73386.14FEDB...tele.dk... (...) yellow=used for yellow sensors(touch, temperatur), sensors needs no power to work. blue=used for light and angle sensors, these sensors needs power (...) (24 years ago, 8-Mar-01, to lugnet.dacta, lugnet.technic, lugnet.robotics.rcx.robolab)

		Re: Guide to Control Lab
1. The yellow inputs are for digital sensors (temperature and touch). The blue are for analog (rotation and light). 2. It's an emergency stop. With the original software, it just stops execution. Don't know if it's implemented with the ActiveX thing (...) (24 years ago, 8-Mar-01, to lugnet.dacta, lugnet.technic, lugnet.robotics.rcx.robolab)

		Re: Guide to Control Lab
active X control? (...) (24 years ago, 18-Mar-01, to lugnet.dacta, lugnet.technic, lugnet.robotics.rcx.robolab)

8 Messages in This Thread:

Entire Thread on One Page:: Nested: All | Brief | Compact | Dots
Linear: All | Brief | Compact

Custom Search