 | | Re: resistance on axle with a worm gear?
|
|
(...) Oops! I thought you wanted to prevent the worm gear from sliding completely. You know, since the length of the worm gear is slightly shorter than two studs, it will slide a little and you have to leave a gap between the two bushes to lock it (...) (25 years ago, 26-Jan-01, to lugnet.technic)
|
| |
| | Re: CV joint compatibility question
|
|
(...) Thanks for the link. Those large pulleys fit into the joints quite nicely. BTW that site is great! I need to try doing some of those things... (25 years ago, 26-Jan-01, to lugnet.technic)
|
| |
| | Re: LEGO on my mind
|
|
This is definately a great site and is where I found the joystick design I based the version in my aeroplane on. The other great site I frequent is (URL)If you are not familiar with the "LEGO on my mind" sight, (...) (25 years ago, 26-Jan-01, to lugnet.technic)
|
| |
| | Re: CV joint compatibility question
|
|
(...) Yes. (URL) you're tinkering with an 8880 you owe it to yourself to check out the entirety of this Cool LEGO Site of the Week from some weeks back. (25 years ago, 26-Jan-01, to lugnet.technic)
|
| |
| | CV joint compatibility question
|
|
Just had a question on the "CV joints" that are used on the 8880 Super Car; is there a way to affix them to wheels other than the wheels that come with this set? The 8880 wheels have a little slot that allows the joint to fit neatly in place, but I (...) (25 years ago, 26-Jan-01, to lugnet.technic)
|
