 | | Re: Technic Pendulum Clock progress —John Morgan
|
| | | (...) I know there are some clock design pictures here in LUGNET® somewhere.you might try searching for "clock". two things that might increase your time is a little more weight on the pendulum and removing the pully on the lead weight. If I recall (...) (24 years ago, 25-Nov-00, to lugnet.technic)
|
| | | |
| | | | | Re: Technic Pendulum Clock progress —Amnon Silverstein
|
| | | | John, I have seen these two other clocks, and a few electric Lego clock designs. I went back to these pages, and I found out that they do have enough information to calculate efficiency. I built an approximate copy of the Zef Damen clock's weight, (...) (24 years ago, 26-Nov-00, to lugnet.technic)
|
| | | | |
| | | | | | Re: Technic Pendulum Clock progress —Amnon Silverstein
|
| | | | I finally got my clock to run for a solid 24 hours (plus only a few more minutes until the weights hit the floor.). It ran the whole period non-stop, and I didn't touch it until it finished its run. It was 15 minutes slow by the end of this period, (...) (24 years ago, 29-Jan-01, to lugnet.technic)
|
| | | | |
| | | | | | Re: Technic Pendulum Clock progress —Chris Daniel
|
| | | | (...) I set up a winder for a spool, I used a worm gear with a 1/5 ratio to the spool when you wind the wheight the string travels down the spool evenly. I got the idea from a hose winder. but unlike a hose winder the lego spool does not travel up (...) (24 years ago, 30-Jan-01, to lugnet.technic)
|
| | | | |
| | | | | | Re: Technic Pendulum Clock progress —Ross Crawford
|
| | | | You could have 2 worm gears side by side turning in opposite directions and have a bar below that which pushes the string against one or the other in turn. I looked at this for my crane spooler, but couldn't get it to work neatly because of the high (...) (24 years ago, 31-Jan-01, to lugnet.technic)
|
| | | | |
